Plastics & rubber

AI vision for injection moulding and rubber parts

Short shots, flash, sink marks and missing inserts caught at the press, and seals and O-rings verified before assembly.

Test it on your parts +39 049 825 6850

Free test on 20 parts
Results in 5 to 7 days
Running in one day
From €1,200/mo, no CAPEX

Injection-moulded part with ten numbered points checked for presence — 10 / 10

What it checks

The defects that cost plastics & rubber producers the most.

Trained on your parts, with your OK and NG examples. Each decision is stored with its image.

Short shots
Flash and burrs
Sink marks and voids
Colour deviation
Missing inserts
O-ring and seal presence

Moulded plastic part with eleven numbered checkpoints, each scored for compliance — 11 checkpoints

Scan result screen: a rubber stopper photographed from above and passed by the quality check — Stopper check

PIQAPART screen confirming a moulded cover with every checkpoint OK and a running total — OK 10 · NG 0

Why it matters

Where manual inspection breaks down.

The same three problems come up on almost every first call in this sector.

01
Defects run for a whole shift

A drifting tool makes bad parts until someone notices. An inline check flags it on the first bad shot.
02
Black rubber is hard to see

Missing O-rings on dark parts escape visual checks. The camera sees presence and position every time.
03
Scrap eats the margin

Catching a problem at the press instead of at assembly saves the parts made in between.

Application · Moulding

Inline defect detection at the moulding press

detection accuracy: 99%+; detection accuracy
scrap: −60%; scrap
to ROI: 3 to 4 mo; to ROI

Read the full case

How it works

From your parts to a running station in three steps.

No machine vision engineers on your side, and no CAPEX: hardware, software, installation and support are one monthly fee.

1
Free test

Send about 20 good and defective parts or high-res photos. We train a model and report detection rate, false positives and cycle time in 5 to 7 days.
2
Install in one day

Camera, lighting and edge PC mounted at your station. Operators see OK or NG, with the defect marked on the image.
3
Improve every week

Every result is logged. When your parts or specs change, we retrain the model as part of the plan.

Applications

AI vision in plastics & rubber, in detail.

Questions

What plastics & rubber teams ask first.

Rather talk it through? Call +39 049 825 6850 or write to info@logirobotix.com.

Can it sit right next to the press?

Yes. The camera and edge PC mount at the press or the robot take-out, so every shot is checked.

Can it tell us when the tool drifts?

Every result is logged, so a rising NG rate on one cavity is visible long before it becomes a batch.

What about transparent parts?

Transparent parts need special lighting. We set it up for your parts on the free test.

Free feasibility test

Test it on your parts.

Send us 20 defective parts or high-res photos. We train a model on your parts and show you detection rate, false positives and cycle time before you sign anything.

parts or photos: 20; parts or photos
days to results: 5-7; days to results
no commitment: €0; no commitment